Part Number : NPE

Proprietary passive high power POE Multi-Giga Injector

PCBA Model : BMJ-1004

Only PCBA Board

Introduction

This Proprietary Passive high power Multi-Giga PoE Injector compliant with IEEE 802.3af/at standard and compliant with 802.3bt power level. This high power POE Injector is designed to supply operational power to PoE PD devices. With Power over Ethernet devices installed, the system administrator only has to use a single RJ-45 Ethernet cable to carry both power and data to each device. It provides Multi-Giga (1/2.5/5G) Ethernet connection ability. It is a cost-effective solution for where the power socket are not readily available.

Highlight Features

  • Complying with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX, IEEE802.3ab 1000Base-T, IEEE 802.3bz 2.5G/5G BASE-T standard
  • Supports 1/2.5/5G Multi-Gigabit Ethernet speed
  • Passive PoE (Compatible to 802.3af/at/bt power level)
  • Provides Passive High Power PoE output ability up to 802.3bt power level
  • Low cable-loss and remote power feeding up to 100 meters
  • Over Current Protection and Short-circuit Protection
  • Supports wall mounting and multiple units combination

Hardware Specification

 
Product Proprietary passive high power POE Multi-Gigabit Injector
Standard IEEE802.3 10BASE-T

IEEE802.3u 100BASE-TX

IEEE802.3ab 1000Base-T

IEEE 802.3bz 2.5G/5GBASE-T

Passive PoE (Compatible to 802.3af/at/bt power level)

Network Media 10BASE –T: UTP Cat. 3 or up

100BASE-TX : UTP Cat. 5 or up

1000BASE-T: UTP Cat. 5e or up

2.5G/5GBASE-T : UTP Cat.5e or up

Data Transfer Rate 100M/1G/2.5G/5G (Half-duplex),

200M/2G/5G/10G (Full-duplex)

PoE Type End-span (Type-A): PIN 1/2,3/6

Mid-span (Type-B): PIN 4/5,7/8

Twisted-pair Used 4Pair
Power Interface Input : DC In

Output : RJ45 POE out

Power Requirement External Power Supply

Input Voltage: 50 ~ 57Volt

Power Supply Optional (60W, 90W)
LED Definition System: Power (Green) x1

l  Light On: Power on

l  Light Off: Power off

Temperature Operating : 0° to 55° C

Storage: -40° to 70° C

Humidity 5% to 90% non-condensing
Dimension

( W x D x H )

NPE : 53.96*41*23mm

BMJ-1004 : 35 *35 mm

Weight NPE : 28.4g

BMJ-1004 : 16g

Case of material ABS
Certifications TBD

** Specifications can be negotiated separately according to needs.