Model Number : NPE03GE-T

Proprietary passive POE Gigabit Injector

PCBA Model : BGJ-1101

Only PCBA Board

Introduction

The Proprietary Passive Gigabit PoE Injector compliant with IEEE 802.3af/at standard. It is suitable for use with products that basically does support Power Over Ethernet. Simply connect the power source to the Adapter, and then use a Gigabit Ethernet cable to connect the Adapter to the device. It is a cost effective solution for deploying Gigabit PoE Wireless Access Points, VOIP Phones, and PoE IP Surveillance environments where the power sources are not readily available.

Highlight Features

  • Complying with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX and IEEE 802.3ab 1000Base-T
  • Supports 10/100/1000M Gigabit Ethernet speed
  • Passive PoE (Compatible to 802.3af/at)
  • Low cable-loss and remote power feeding up to 100 meters
  • Over Current Protection and Short-circuit Protection
  • Supports wall mounting and multiple units combination

Hardware Specification

 
Product Proprietary Passive PoE Gigabit Injector
Standard IEEE802.3 10BASE-T

IEEE802.3u 100BASE-TX

IEEE802.3ab 1000Base-T

Passive PoE (Compatible to 802.3af/at)

Network Media 10BASE –T: UTP Cat. 3 or up

100BASE-TX : UTP Cat. 5 or up

1000BASE-T: UTP Cat. 5 or up

Data Transfer Rate 10/100/1000Mbps (Half-duplex),

20/200/2000Mbps (Full-duplex)

PoE Type Mid-span (Type-B): PIN 4/5,7/8
Power Interface Input : DC In

Output : RJ45 POE out

Power Requirement External Power Supply

Input Voltage: 44 ~ 57Volt

Power Requirement External Power Supply ,

Input Voltage: 44 ~ 57Volt

Power Supply Optional (24W, 30W)
LED Definition System: Power (Green) x1

l  Light On: Power on

l  Light Off: Power off

Temperature Operating : 0° to 55° C

Storage: -40° to 70° C

Humidity 5% to 90% non-condensing
Dimension

( W x D x H )

NPE03GE-T : 53.96*41*23mm

BMJ-1005 : 35 *35 mm

Weight NPE03GE-T : 30g

BMJ-1005 : 17.6g

Case of material ABS
Certifications TBD

**Specifications can be negotiated separately according to needs.